Replacing A Water Sensor (Rope Type) - Huawei IDS1000-A Maintenance Manual

IDS1000-A Air-Cooled Container Data Center
All-in-One Maintenance Guide
Figure 5-14 Removing a point-type water sensor
Step 3 Install a new water sensor and tighten the screws.
Step 4 Connect cables to the water sensor.
Step 5 Check that the new water sensor is working properly.
----End
Follow-up Procedure
Dispose of the removed water sensor that is confirmed faulty.

5.3.3 Replacing a Water Sensor (Rope Type)

Prerequisites


Impact on the System
None
Preparations
Tools: Phillips screwdriver, protective gloves
Material: spare water sensor
Document required: monitoring device layout diagram
Skill requirement: weak-current engineer
Issue 01 (2016-01-10)
Drip a small amount of water onto the water sensor. If the monitoring software terminal generates an
alarm, the water sensor is working properly.
A water sensor needs to be replaced.
Spare water sensors of the same model are available and functional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
95