Replacing A Vcn500 - Huawei IDS1000-A Maintenance Manual

IDS1000-A Air-Cooled Container Data Center
All-in-One Maintenance Guide
Skill requirement: weak-current engineer
Procedure
Step 1 Remove screws securing the camera cover using a dedicated hex key.
Step 2 Use a Phillips screwdriver to remove the screws that fasten the camera to its base.
Step 3 Remove the network cable and take out the camera.
Step 4 Install a spare camera, connect the network cable, and secure the camera cover with its the
base.
Step 5 Check that the new camera is working properly.
Step 6 Configure the camera by referring to the management system initial configuration table.
Step 7 Adjust the camera coverage by following the instructions in documents delivered with the
camera.
----End
Follow-up Procedure
Dispose of the removed camera that is confirmed faulty.

5.3.9 Replacing a VCN500

Prerequisites


Impact on the System
The operation of the monitoring system or devices may be interrupted.
Preparations
Tools: Phillips screwdriver, small-sized flat-head screwdriver, ESD gloves, marker
Material: spare VCN500
Documents required: documents delivered with the VCN500
Skill requirement: weak-current engineer
Issue 01 (2016-01-10)
For the table, see the initial configuration guide.
If the red indicator of the camera is on, the camera is working properly.
The original parameter settings can be used.
A VCN500 needs to be replaced.
A spare VCN500 of the same model is available and functional.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Parts Replacement
104