Water Intrusion Alarm - Huawei IDS1000-A Maintenance Manual

IDS1000-A Air-Cooled Container Data Center
All-in-One Maintenance Guide
Fault
Category

4.13 Water Intrusion Alarm

Fault
Category
Water
Intrusion
Alarm
Issue 01 (2016-01-10)
Alarm Symptom
Severity
The access card
cannot be read.
Alarm Symptom
Severity
General There is no water
onsite.
There is water
onsite.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Possible Troubleshooting
Cause
The access card Prepare a new access
is damaged. card and assign the
access permission.
The card reader Verify the card reader
is faulty. cable connections, or
replace by following
instructions in
Replacing a Card
Reader.
Possible Troubleshooting
Cause
The water For details, see
sensor is faulty. Replacing a Water
Sensor (Rope Type)
5.3.2 Replacing a Water
Sensor (Point
A pipe is Contact Huawei
damaged. technical support.
A humidity Replace by following
water refill pipe instructions in
is damaged. Replacing the
Humidifier Water Refill
Pipe for a Precision Air
Conditioner.
The condensate Replace by following
drainpipe is instructions in
damaged. Replacing the
Condensate Drainpipe
of a Precision Air
Conditioner.
The condensate Remove the drainpipe
drainpipe is outside the container,
blocked.
and dig out the material
blocking the pipe using
a thin iron wire.
The Replace the
dehumidifier dehumidifier drainpipe.
drainpipe is
damaged.
4 Alarms and Faults
5.3.13.1
5.3.3
or
Type).
5.2.7.1
5.2.7.2
57