gefran AFE200 4 Series Instruction Manual page 80

Menu PAR Description
1.21 1400 Digital output X mon
The status of the digital outputs of the expansion card is displayed. It can also be read
via a serial line or fieldbus. The data are contained in a word, where each bit is 1 if
voltage is supplied to the corresponding input terminal.
0 Output disabled
1 Output enabled
I.e. :
Menu PAR Description
1.22 5400 Dig inp 0Ext mon
This parameter displays the state of external inputs from 0 to 31 through the use of
EXP-FL-XCAN-ADV optional card.
Menu PAR Description
1.23 5402 Dig inp 1Ext mon
This parameter displays the state of external inputs from 32 to 63 through the use of
EXP-FL-XCAN-ADV optional card.
Menu PAR Description
1.24 5450 Digital out 0Ext mon
This parameter is used to read the state of external outputs from 0 to 31 through the
use of EXP-FL-XCAN-ADV optional card.
Menu PAR Description
1.25 5452 Digital out 1Ext mon
This parameter is used to read the state of external outputs from 32 to 63 through the
use of EXP-FL-XCAN-ADV optional card.
Menu PAR Description
1.26 1060 Sequencer status
Drive state parameter. Provides the AFE's operating and activation state and is
responsible for protection and alarm conditions, the command sequence and reset
condition.
0
Init
1 Wait Vdc Ok
2 Delay
3 Offset Calc
4
Ready
5 Run
6 Alarm Disabled
7 Alm End Action
8
Alm return
9 Alm no restart
80
UM Type
UINT16
000000000011
000000000011
Active DO 2 Active DO 1
UM Type
UINT32 32BIT
UM Type
UINT32 32BIT
UM Type
UINT32 32BIT
UM Type
UINT32 32BIT
UM Type
ENUM
AFE200 • Instruction Manual
FB BIT Def
0
FB BIT Def
0
FB BIT Def
0
FB BIT Def
0
FB BIT Def
0
FB BIT Def
16 Init
Min Max Acc
0 0
Min Max Acc
0 ER
4294967295
Min Max Acc
0 ER
4294967295
Min Max Acc
0 0 ER
Min Max Acc
0 0 ER
Min Max Acc
0 0 ER
R