gefran AFE200 4 Series Instruction Manual page 127

Menu PAR Description
14.2.4 4010 Fieldbus M->S enable
Setting of fieldbus data updating.
0 Disable
1 Enable
If set to 0, the possibility of sending commands and references from the AFE PLC via
the fieldbus is disabled.
If set to 1 the possibility of sending commands and references from the AFE PLC via
the fieldbus is enabled.
Menu PAR Description
14.2.5 4012 Fieldbus alarm mode
Setting of the Opt Bus Fault alarm generation mode.
0 Off
1 On
If set to 0 the alarm is only generated if the AFE is enabled.
If set to 1 the alarm is generated even with the AFE disabled.
Menu PAR Description
14.2.6 4014 Fieldbus state
The logic status of the fieldbus connection is displayed. The value depends on the
type of bus that is used.
These logic states are displayed if the selected fieldbus is CANopen or RTE:
0 Stop
1
PreOperational
2 Operational
These logic states are displayed if the selected fieldbus is Profibus:
3 Error
4
WaitPRM
5 WaitCFG
6 DataExchange
7 DPError
The following logic states are displayed if the RTE field bus is selected:
8 SAFE OP
9 INIT
Menu PAR Description
14.2.7 4398 RTE protocol
The Real Time Ethernet protocol implemented on the expansion card is displayed.
0 None
1 Ethercat
2
EthernetIP
3 GdNet
4 Profinet
5 ModbusTCP
6 Powerlink
UM Type FB BIT
ENUM
UM Type FB BIT
INT32
UM Type FB BIT
ENUM
UM Type FB BIT
ENUM
AFE200 • Instruction Manual
Def Min
Enable 0
Def Min
0 0
Def Min
Stop 0
Def Min
None 0
Max Acc
1 ERWZ
Max Acc
1 ERWZ
Max Acc
7 R
Max Acc
6 ER
127