Load Parameters From Keypad; Transfer Of Parameters Between Afe200 - gefran AFE200 4 Series Instruction Manual

If an error occurs during transfer, the following message is displayed:
T+
Message
Save par failed
Code:
Press ESC to exit
The code XX indicates the type of error, see
To exit from the error message, press the ESC key.

6.8.3 Load parameters from keypad

Menu 04 DRIVE CONFIG, parameter 04.20 Load par from keypad, PAR : 592.
Is used to transfer the parameters from the selected memory of the keypad to the
AFE.
T+
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
To start the operation, press the E key. During transfer, a bar is displayed which
indicates progress of the operation.
Instead of the letter X, the number of the currently selected keypad memory is
displayed.
At the end of transfer, if this has been completed successfully, the "Done" caption
is displayed for a few seconds with subsequent return to the initial page.
If an error occurs during transfer, the following message is displayed:
T+
Message
Load par failed
Code:
Press ESC to exit
The code XX indicates the type of error, see
To exit from the error message, press the ESC key.

6.8.4 Transfer of parameters between AFE200

Transfer the parameters of the source AFE to the keypad memory as indicated in
paragraph
to be saved and proceed as indicated in paragraph 6.8.3.
To prevent possible damage to equipment, it is advisable to disconnect and con-
nect the keypad with the AFE OFF.
Caution
Pour éviter tout endommagement possible des appareils, il est conseillé de débrancher et de
brancher le pavé de commande une fois le AFE éteint.
T- EN LOC ILim n:0 AL
0 1
XX
T - EN LOC ILim n:0 AL
T- EN LOC ILim n:0 AL
0 1
XX
6.8.2, then connect the keypad to the AFE on which the new setting is
AFE200 • Instruction Manual
paragraph
T+ T- EN LOC ILim n:0
X 2
0 4 . 2 0 PA R : 5 9 2
Load par from keypad
Press E to execute
paragraph
9.2.
AL T+ T- EN LOC
0 4 . 2 0 PA R :
E
DRIVE <-- K2006 X
9.2.
ILim n:0 AL
5 9 2
67