[Cm71] Memory Allocation For System Speed Dialing - NEC UNIVERGE SV8300 Command Manual

Hide thumbs Also See for UNIVERGE SV8300:

Table of Contents

COMMAND CODE TITLE:

This command is used to allocate memory area for System Speed Dialing to tenants, attendants, Hot

Line-Outside and Delayed Hotline-Outside station.

System Speed Dialing has 300 memory locations system-wide; this is referred to as a "Memory

Block" (See Figure below).

Each location where a dialed number is stored is called "Memory Slot".

Example: The System Speed Dialing memory is assigned to three tenants as follows;

MEMORY ALLOCATION FOR SYSTEM SPEED DIALING

Memory Block

NUMBER OF SLOTS

RANGE OF SLOT

Continued on next page

NWA-033623-001 Rev.8.1

JULY/17/2009