NEC UNIVERGE SV8300 Command Manual page 206

COMMAND CODE TITLE:
10
Setting method of Port number/Station number in Dual port mode
When using Analog Port Adapter and PGD(2)-U10 ADP in Dual port mode
numbers (17-32) of the DLC blade slot which accommodate Digital Multiline terminal/PGD(2)-
U10 ADP are used for the virtual station. Therefore, the virtual station number for Single Line
Telephone/PGD(2)-U10 ADP need to be registered to the Circuit numbers (17-32). Then, match
the Circuit numbers (01-16) of the physical station and the Circuit numbers (17-32) of the virtual
station (see figure below). For example, the Circuit number 17 corresponds to Single Line Tele-
phone connected to the Circuit number 01 of Digital Multiline Terminal.
Example:
• CM10 Y=00>010101: F200 (Station number of Digital Multiline Terminal)
• CM10 Y=00>010117: F300 (Station number of Single Line Telephone)
Digital Multiline Terminal/
Station number of
PGD(2)-U10 ADP
Single Line Telephone/
Virtual station number of
PGD(2)-U10 ADP
NOTE 1: When 2 Paging equipment are connected to a PGD(2)-U10 ADP, the setting of Dual port
mode is required as with Analog Port Adapter (related command: CM13 Y=32/33/34).
NOTE 2: The virtual station needs system capacity licenses only for the number of ports to be used.
Even when the virtual station is not connected, to just set the data for Dual port mode be-
comes the subject of license.
STATION NUMBER, TRUNK NUMBER, BLADE NUMBER
Circuit number=01-16 Physical station
01 02 03 04 05 06
Connection
17 18 19 20 21 22
Circuit number=17-32 Virtual station
DLC blade
07 08 09 10 11 12
23 24 25 26 27 28
3-150
NOTE 1, the Circuit
13 14 15 16
29 30 31 32
Continued on next page
NWA-033623-001 Rev.8.1
CM10
91ch3002.fm
JULY/17/2009