System Data Memory All Clear/Sram Clear - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
00
FUNCTION:
This command is used to confirm that system data memory (RAM) area billing memory area (SRAM)
can be written-in/read-out, and to assign the default to the RAM area or SRAM area.
PRECAUTION:
(1) This command can only be used in off-line mode.
(2) When this command is executed, "OK" is displayed with memory clear completed (about 10
seconds later).
(3) If an error exists in memory, "WD ERROR" is displayed.
(4) This command is not available with a CAT.
To clear all system data, set SENSE switch on the CPU blade accommodated in Unit01 to "A", and
depress RESET switch on the CPU blade accommodate in Unit01. In this case, the only functional
port is Physical Port No. 010101 or Virtual Port No. 0000, which is assigned as a CAT.
(5) The SRAM area data which is cleared by CM00>02,10,11 is as follows.
SRAM AREA DATA
Fault Information
OAI FLF Memory
Roaming Backup Memory
Billing Memory
VRS built-in CPU (Voice Data)
Call Charge Output to SMDR
Other SRAM Area Data
ASSIGNMENT PROCEDURE:
+ 00 + DE +
ST
SYSTEM DATA MEMORY ALL CLEAR/SRAM
CLEAR
02







MEMORY AREA
+ DE
DESIGNATION
(1/2digit)
1ST DATA
10 11
– –
– –
– –

–

–

–
– –
+ CCC + EXE
3-3
CM00
OFF LINE
:Cleared data
RELATED COMMAND
CM04 Y=01>12,
CM08>896
CM04 Y=01>12
NWA-033623-001 Rev.8.1
91ch3001.fm
APRIL/16/2010