[Cm45] Make Busy Condition Of Cft/Dtmf Receiver Detect Level - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
45
FUNCTION:
This command is used to define the make busy condition of built-in CFT on CPU or to set DTMF
Receiver detect level.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
ST + 45Y + DE
DATA TABLE:
Y
No. MEANING
6 Make busy condition
of CFT
[8300R2]
NOTE 1: Set this data when CPU built-in CFT is secured for Conference.
NOTE 2: Each unit has 16 circuits for built-in CFT on CPU.
NOTE 3: When using Three Party Conference, each group uses one CPU built-in CFT circuits.
NOTE 4:
When using Conference, four participants or less can connect to one CPU built-in CFT circuits.
(ex.) Set two circuits to make busy for one 8-party conference.
MAKE BUSY CONDITION OF CFT/DTMF RECEIVER DETECT LEVEL
1ST DATA
+ + DE
(2-3 digits)
1ST DATA
DATA MEANING
00 CPU built-in CFT circuit
number
15
2ND DATA
+ + EXE
(1-2 digits)
DATA
0
3-389
2ND DATA
MEANING
Make busy
1 In service
Continued on next page
NWA-033623-001 Rev.8.1
CM45
: Default
91ch3004.fm
APRIL/16/2010