[Cm0B] Lan Data Assignment - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
0B
FUNCTION:
This command is used to assign the LAN data for Maintenance port of CPU blade and VOIP port of
VoIPDB. Set each port by the operational pattern to be used. For details, refer to PRECAUTION (1) on
this page.
PRECAUTION:
(1) The table below shows the operational patterns for each setting port.
FUNCTION
• PCPro
• IP Station and Legacy Terminal/
trunk connection
• IP Station (P2P connection)
• IPT (P2P CCIS)
• Remote Unit over IP
• Stand alone (more than 2 Units con-
figurations)
• SMDR (LAN Interface)
• PMS (LAN Interface)
• OAI
• SNMP
• SIP trunk
In default setting, the port to be connected is the VOIP Port. Therefore, change the port by CM0B
Y=001>91, 92 when connecting to the Maintenance Port.
Assign the commands of SNMP to the Maintenance Port.
SNMP information can be obtained from the Maintenance port and the VOIP port.
(2) CM0B Y=1XX is associated with setting the system data for Control Signals, and Y=2XX is
associated with setting the system data for Voice Packets.
LAN DATA ASSIGNMENT
MAINTENANCE
: To assign –: Not assigned ( ): Y number
PORT
VOIP PORT
PORT
 
(0XX) (1XX)

–
(1XX/2XX)
 
(001) (101)
 
(001) (–)

–
(101/201)
3-90
CM0B
REMARKS
Available to use both ports at
the same time
Not available to use both
ports at the same time
Continued on next page
NWA-033623-001 Rev.8.1
91ch3001.fm
APRIL/16/2010