[Cm42] Codec List - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
42
CODEC List
1ST DATA (CODEC TYPE)
DATA
100 Priority 1-4 in CODEC list 0
103
120 Priority 1-4 in CODEC list 1
123
140 Priority 1-4 in CODEC list 2
143
160 Priority 1-4 in CODEC list 3
163
NOTE 1: G.711 is automatically corrected according to the μ-law/A-law on the system.
NOTE 2:
G.722 (Wide Band Codec) is available only when using DT700 Series (DT730/DT750)/
SP350/VoIPDB (PZ-64IPLA/PZ-128IPLA)/Standard SIP station.
NOTE 3:
Although G.722 (Wide Band Codec) is not available for VoIPDB (PZ-64IPLC-A/PZ-
128IPLC-A), when only G.722 is set on the CODEC list, the CODEC is converted into
G.711. However, in this state, when the opposite office connected via IPT (P2P CCIS) is
also set to G.722 only, a call is not available because there is no available CODEC.
Therefore, set this data including the available CODEC (G.711 or G.729a).
NOTE 4:
G.723.1 is not available when using DT700 Series/D
MH240/VoIPDB (IP-PAD/IPT [P2P CCIS])/Standard SIP station.
CODEC LIST
MEANING
2ND DATA
DATA MEANING
01 G.711 µ-law 64 K
02 G.711 A-law 64 K
03 G.723.1 (5.3/6.3K)
04 G.729a
07 G.722 (Wide Band Codec)
NONE No data
term
IP INASET/D
3-378
: Default
REMARKS
NOTE 1 CM67
NOTE 1
NOTE 4
NOTE 2, NOTE 3
term
SP30/SP350/
Continued on next page
NWA-033623-001 Rev.8.1
JANUARY/31/2012
CM42
91ch3004.fm