[Cma7] Ccis Channel/Ip Trunk/Sip Trunk Data - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
A7
FUNCTION:
This command is used to assign the various data to each Common Channel Handler (CCH), IP Trunk
and SIP Trunk provided.
PRECAUTION:
When setting the IPT (P2P CCIS) No. with this command, be sure to set the first data to "00".
ASSIGNMENT PROCEDURE:
ST + A7YY + DE
DATA TABLE:
CCIS CHANNEL DATA
Y
No. MEANING
00 Trunk used as Common Signaling
channel/IPT (P2P CCIS)/SIP trunk
01 Originating Point Code (OPC)
NOTE 1: The Originating Point Code is used to designate an originating office in the No. 7 CCIS network.
A single OPC should be assigned to IPT No. 0 and all other IPT (P2P CCIS) provided in the same
office.
NOTE 2: Do not change this data while the system is operating. If you do that, the operation of IP Stations
will be unstable.
CCIS CHANNEL/IP TRUNK/SIP TRUNK DATA 1
+ CCH/IPT/SIP TRUNK No. (00-15)
NONE
RESET
NONE
+ DE
SETTING DATA
DATA MEANING
000 Trunk number assigned by CM10
Y=00
511
No data
00001 Originating Point Code
16367
No data
3-573
DATA
+ + EXE
(1-5 digits)
RELATED
COMMAND
CM10 Y=00
Continued on next page
NWA-033623-001 Rev.8.1
CMA7
: Default
91ch3007.fm
JUNE/15/2011