Cat Key Functions - NEC UNIVERGE SV8300 Command Manual

CAT KEY FUNCTIONS

In the CAT mode, each key on the Multiline Terminal is automatically assigned as shown in figure below.
For the function of each key, see
CAT key assignment is different between 8300R2 software or before and 8300R3 software or later. Set
CM08>911 to 0 when CAT key assignment of 8300R2 software or before is used.
• CM08>911 (Layout the key on CAT mode)
2nd data: 0 (Old layout [8300R2 or before])
: 1 (New layout [8300R3 or later])
NOTE:
Only New layout can be used regardless of this command when using DT330 DESI-less or
DT730 DESI-less, DT710 DESI-less, DT750.
"CAT Function Keys".
[8300R3]
1-3
Chapter 1 HOW TO USE CAT
Page 1-15
CAT KEY FUNCTIONS
NWA-033623-001 Rev.8.1
91ch1001.fm
JUNE/15/2011