NEC UNIVERGE SV8300 Command Manual page 405

COMMAND CODE TITLE:
41
1ST
Y MEANING
DATA
0 133 Expire value for
DT700 Series SUB-
SCRIBE for Server
(Day)
134 Expire value for
DT700 Series SUB-
SCRIBE for Server
(Hour)
135 Expire value for
DT700 Series SUB-
SCRIBE for Client
(Minute)
SYSTEM TIMER DATA
DEFAULT
NONE 00 01 02 .........................................................99
1 hour 0
NOTE 1: Usually, this data setting is not required.
NOTE 2: This data implies the expire value for the DT700 Series
SUBSCRIBE (terminal control signal from DT700 Series
to SV8300) and is set by the combination of CM41
Y=0>133-135 (day/hour/minute).
When CM41 Y=0>133-135 (day/hour/minute) are all set
to NONE, the expire value "3600 seconds" is set as de-
fault.
NOTE 3:
The DT700 Series updates the SUBSCRIBE at half inter-
val of the value set by this data.
NOTE 4:
The load to SV8300 increases if small amount of data
(such as 1 minute) is set. Therefore, it is recommended to
set the value more than 1 hour (3600 seconds).
NOTE 5: After setting this data, a reset of the terminal is required.
NONE 00 01 02 .........................................................23
1 hour 0
NOTE:
NONE 00 01 02 .........................................................59
1 hour 0
NOTE:
2ND DATA
TIMER
1 2 ..........................................................99
1 2 ..........................................................23
See NOTE 1 through NOTE 5
Y=0>133.
1 2 ..........................................................59
See NOTE 1 through NOTE 5
Y=0>133.
3-349
INCREMENT
UNIT
1 day
1 hour
on CM41
1 minute
on CM41
Continued on next page
NWA-033623-001 Rev.8.1
91ch3004.fm
JANUARY/31/2012
CM41