[Cme6] Call Forwarding Set/Reset From Pcpro/Cat - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
E6
FUNCTION:
This command is used to set/reset Call Forwarding service to each station from a PCPro/CAT.
PRECAUTION:
CME6 can be used for any station irrespective of its state.
ASSIGNMENT PROCEDURE:
ST + E6YY + DE
DATA TABLE:
Y MEANING
00 Call Forwarding-All Calls
01 Call Forwarding-Busy Line
02 Call Forwarding-No Answer
03 Call Forwarding-Busy Line/No
Answer
04 Split Call Forwarding-All Calls
05 Split Call Forwarding-Busy Line/No
Answer
NOTE: To reset the Call Forwarding, assign "CCC" to the second data.
CALL FORWARDING SET/RESET FROM PCPro/CAT
STATION No.
+ + DE
(1-8 digits)
• Destination=Extension;
X-XXXXXXXX: Station No. (1-8 digits)
• Destination=Outside party;
X-XXXX +
X-XXXX: Outgoing Trunk/LCR Group Access Code (1-4 digits)
,
YY...YY : Called No. (Maximum 26 digits)
• Destination=Attendant; E000
[8300R2]
NONE
0: Destination for Split Call Forwarding (Block 0)/ATT
1: Destination for Split Call Forwarding (Block 1)
2: Destination for Split Call Forwarding (Block 2)
3: Destination for Split Call Forwarding (Block 3)
4: Destination for Split Call Forwarding (Block 4)
5: Destination for Split Call Forwarding (Block 5)
6: Destination for Split Call Forwarding (Block 6)
7: Destination for Split Call Forwarding (Block 7)
8: Destination for Call Forwarding
9: Destination for Station Speed Dialing (Block 0)
NONE
DESTINATION No.
+
(1-31 digits)
DESTINATION
,
+ YY...YY
: Separate Mark
: No data
: No data
3-655
CCC
+ EXE
(for reset)
: Default
Continued on next page
NWA-033623-001 Rev.8.1
NOVEMBER/12/2008
CME6
See
CM78
91ch3008.fm