NEC UNIVERGE SV8300 Command Manual page 48

CONDITION
Commands which require a
reset of the blade after data
setting.
• Executed by CME0 Y=3
BLADE RESET
NOTE 1: When CM10 Y=00: DXXX is executed, a blade reset by CME0 Y=3 is required only for LDT/
ODT/DTI.
NOTE 2: Whether a blade reset is required in these commands depends on blade type.
See PRECAUTION (2) of CM35
Conditions for Using Commands
COMMANDS
CM04 Y=10-59>01, 02
CM05 Y=0, 1
CM08>644
CM10 Y=00: DXXX,
E000-E007
NOTE 1
CM13 Y=32, 33, 63
CM30 Y=00
CM35 Y=001, 009, 020,
023, 025, 079, 089, 104,
105, 113, 129, 144, 291
NOTE 2
CM41 Y=0>38, 142,
Y=1>20, 22, 23, Y=2>
50-77, 80-87, Y=3>20-26,
30-44, 49-51, 60-63
CMA9
CMAA Y=00-02, 06, 09,
19-21, 25
CMAC Y=01, 03, 16
CMAE Y=00>03, 05
Y=10, 11, 15, 19, 42
CMEE
2-4
Chapter 2 PRECAUTION
CONDITIONS FOR USING COMMANDS
MEANINGS
Setting of System Services
Blade Type, Trunk Blade Number, Highway
Channel for ISDN Data Communication
Basic Services
Station Number, Trunk Number, Blade Num-
ber
Station Class-2
Trunk Data
Trunk Route Data
System Timer Data
ISDN (PRI) D-Channel Assignment
DTI/BRT/PRT/CCT Blade Functions
ISDN Functions
ZT Operation Data Assignment
Application Blade Data Assignment
Continued on next page
NWA-033623-001 Rev.8.1
91ch2001.fm
JANUARY/31/2012