[Cm35] Trunk Route Data - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
35
FUNCTION:
This command is used to assign trunk route characteristics. A trunk route is a group of trunks with com-
mon characteristics used for a common purpose.
PRECAUTION:
(1) When assigning a Tie line, the data in CM35 Y=009 (Incoming connection signaling) should be
similar to that of CM35 Y=020 (Sender starting condition).
The table below shows the assignment of the sender starting condition in relation to the incoming
connection signaling.
INCOMING CONNECTION
SIGNALING (CM35 Y=009)
Ground Start (01)
Loop Start (15)
Wink Start (03)
Delay Dial (04)
Immediate (05)
2nd DT/Timing (06)
NOTE:
( ) indicates the data to be assigned.
TRUNK ROUTE DATA
Ground Start (02)
Loop Start (15)
Wink Start (00)
Delay Dial (01)
Timing Start (15)
Timing Start (15)
SENDER START CONDITION
(CM35 Y=020)
3-286
CM35
REMARKS
NWA-033623-001 Rev.8.1
91ch3003.fm
JULY/17/2009