[Cm31] Mfc/Mf-Ani Trunk Data - NEC UNIVERGE SV8300 Command Manual

COMMAND CODE TITLE:
31
FUNCTION:
This command is used to assign the attribute data to MFC/MF-ANI trunk lines.
PRECAUTION:
None
ASSIGNMENT PROCEDURE:
+ + DE
ST 31Y
DATA TABLE:
Y
DATA
0 0 Nation code
Nation code
[For EU]
NOTE 1:
NOTE 2:
NOTE 3:
MFC/MF-ANI TRUNK DATA
1ST DATA
+ + +
DE
(1-2 digits)
1ST DATA
MEANING
Default of CM31 Y=0>0 depends on each nation code of the CPU program.
For Australia/NZ: 01
For North America: 03
For Asia/Africa/Europe/Latin America/Middle East/Russia: 04
In case of EU, the default of CM31 Y=0>0 is same as North America (nation code 03).
Therefore, you must set the nation code to 05 by this command.
A-law/µ-law setting is decided in the following order.
1. Setting of CM04 Y=10-59
2. Setting by CPU
2ND DATA
+
EXE
(1-2 digits)
DATA
01 Australia
03 North America
RESET
04 Asia/Africa/Europe/Latin America/
Middle East/Russia
15 New Zealand
NONE As per CPU blade
05 Austria/Belgium/Denmark/Germany/Italy/
South Africa/Spain/Sweden/Switzerland/
The Netherlands/UK/Brazil/China/Interna-
RESET
tional/Latin America/Asia
3-270
: Default
2ND DATA
MEANING
Continued on next page
NWA-033623-001 Rev.8.1
APRIL/16/2010
CM31
91ch3003.fm