Dismounting The I/O-Ipc; Disconnecting Cables And Conductors; Figure 13: I/O-Ipc Interfaces - WAGO -I/O-SYSTEM 750 User Manual

40 Installing and Removing the I/O-IPC
6.6

Dismounting the I/O-IPC

To replace an I/O-IPC (e.g., in the event of version change), proceed as described
in the following section.
Hot surface!
The I/O-IPC housing may become hot during operation. If the I/O-IPC has been
in operation, allow it to cool off before moving it.
6.6.1

Disconnecting Cables and Conductors

To remove the cables and conductors, proceed as follows:
1. Disconnect from the power supply those parts of the system on which you
have mounted the I/O-IPC.
2. Disconnect the plugs/sockets from the I/O-IPC interfaces and remove the
data cables.
3 Remove the conductors from the first 750 Series I/O Module connected to
the I/O-IPC (A).

Figure 13: I/O-IPC interfaces

CAUTION
Run
Stop
A
WAGO-I/O-SYSTEM 750
I/O-IPC-C10E, CANopen Master
...