Din Rail Mounting - Siemens LOGO! Series Manual

LOGO! installation and wiring
2.2 Installing/removing LOGO!
2.2.1

DIN rail mounting

Mounting
How to mount a LOGO! Base Module and a digital module onto a DIN rail:
1. Hook the LOGO! Base Module onto the rail.
2. Push down the lower end to snap it on. The mounting interlock at the rear must engage.
3. On the right side of the LOGO! Base Module/LOGO! expansion module, remove the
4. Place the digital module onto the DIN rail on the right-hand side of the LOGO! Base
40
connector cap.
Module.
Manual, 04/2011, A5E03556174-01
LOGO!