Siemens LOGO! Series Manual page 104

Programming LOGO!
3.7 Writing and starting the circuit program
Verification of the circuit program
This program branch for Q1 is now completed. LOGO! shows you the output Q1. You can
once again view the circuit program on the display. Use the keys to browse the circuit
program; that is, press
inputs at a block.
Closing the programming mode
Although you were shown how to exit the programming mode when you created your first
circuit program, here is a reminder:
1. Return to the programming menu: Press ESC
2. Return to the main menu: Press ESC
3. Move the '>' cursor to 'Start': Press
4. Confirm 'Start': Press OK
LOGO! is back in RUN mode:
104
or to move from block to block,
or
and to move between the
Manual, 04/2011, A5E03556174-01
LOGO!