Modifying Parameters - Siemens LOGO! Series Manual

Hide thumbs Also See for LOGO! Series:
Table of Contents

Advertisement

Configuring LOGO!
7.1 Selecting parameter assignment mode
7.1.3

Modifying parameters

You first select the parameter you want to edit (Page 291).
You change the value of the parameter in the same way as you did in programming mode:
1. Move the cursor to the point at which you want to make the change:
2. To change this value: Press
3. To apply the value: OK
Note
When changing the time parameter when the system is in RUN, you can also change the
timebase (s=seconds, m=minutes, h=hours). This does not apply if the time parameter
represents the result of another function (for an example, see the "On-delay (Page 160)"
topic). In this case you can neither change the value nor the timebase. The current time is
reset to zero when you change the timebase.
Current value of a time T
View of a time T in parameter assignment mode:
You can change the configured time T.
Current timer value
View of a timer cam in parameter assignment mode:
You can change the on/off times and the day.
292
Press
or
or
Manual, 04/2011, A5E03556174-01
LOGO!

Advertisement

Table of Contents
loading

This manual is also suitable for:

Logo! basicLogo! pure

Table of Contents