3.7.10
Correcting programming errors
Programming errors can be corrected easily in LOGO!:
● Provided editing mode is not yet closed, you can revert by one step by pressing ESC.
● If you have already configured all inputs, simply reconfigure the faulty input:
1. Move the cursor to the faulty position
2. Change to editing mode. Press OK
3. Enter the correct input circuit
You can only replace a block with a block that has exactly the same number of inputs.
However, you can delete the old block and then insert a new one. You can choose any new
block.
3.7.11
Selecting analog output values for RUN/STOP transition
You can select the analog values that are output at the two analog outputs when LOGO!
changes from RUN mode to STOP mode.
In the programming menu:
1. Move the ">" cursor to "
2. Select "
3. Move the ">" cursor to 'AQ': Press
4. Select "AQ": Press OK
5. Move the ">" cursor to "
LOGO!
Manual, 04/2011, A5E03556174-01
①
": Press
①
": Press OK
②
": Press
3.7 Writing and starting the circuit program
or
or
or
Programming LOGO!
107