Calibrating The Touch Screen - Siemens LOGO! Series Manual

Configuring the HMI device
5.1 Configuring devices with graphical Control Panel
5.1.8

Calibrating the touch screen

This function is only available for touch screen devices.
74
New calibration settings have been measured.
Tap the screen to register saved data.
Wait for 30 seconds to cancel saved data and
keep the current setting.
Time limit: 30 sec
1. Press "OP" to open the
"OP Properties" dialog.
2. Change to the "Touch" tab.
3. Press "Recalibrate" to open the
calibration screen.
4. Touch the cross in the screen center
using the touch pen or your finger.
5. Using the touch pen or your finger,
touch the floating cross in the
corners of the screen.
6. Touch the cross in the screen center
once again using the touch pen or
your finger to confirm your entries.
7. Close the dialog and save your
entries with "OK".
Operating Instructions, 04/2012, A5E02421799-03
Basic Panels