Siemens LOGO! Series Manual page 95

Changing LOGO! from RUN to STOP mode from the LOGO! TD
A change from RUN mode to STOP mode from the LOGO! TD requires password entry if
one is assigned. You must know the existing password if one is assigned. If there is no
password assigned on the LOGO! Base Module, the LOGO! TD will not prompt you for
password entry.
To change LOGO! from RUN mode to STOP mode from the LOGO! TD when LOGO! is
password-protected, follow these steps:
1. On the LOGO! TD, press ESC to switch LOGO! from RUN mode to STOP mode. LOGO!
2. Press OK. The LOGO! TD shows you the following display:
3. Press
4. Press OK to exit the password entry screen form. The LOGO! TD opens the main menu:
The main menu of the LOGO! TD (version ES6 or earlier):
LOGO!
Manual, 04/2011, A5E03556174-01
TD shows the following menu:
to move the cursor to "Yes", and press OK. Enter the correct password (in this
case: "ZZ"). If you enter an incorrect password, the LOGO! TD returns to the display in
Step 1.
Programming LOGO!
3.7 Writing and starting the circuit program
95