Starting Automatic Transfer - Siemens LOGO! Series Manual

6.4.3

Starting automatic transfer

Introduction
If automatic transfer is activated, the HMI device automatically changes to "Transfer" mode
at runtime as soon as a transfer is started on the connected configuring PC.
Note
With automatic transfer, the HMI device only changes into "Transfer" mode when the project
is running on the HMI device.
Automatic transfer is particularly suited for the test phase of a new project since transfer is
completed without interfering with the HMI device.
NOTICE
If automatic transfer is activated on the HMI device and a transfer is initiated on the
configuring PC, the project currently running is automatically stopped. The HMI device then
automatically switches to "Transfer" mode.
After the commissioning phase, deactivate the automatic transfer so that the HMI device
cannot be inadvertently switched to transfer mode. Transfer mode can trigger unintentional
actions in the plant.
You can issue a password in the Control Panel to restrict access to the transfer settings
and thus avoid unauthorized modifications.
Requirements
● The project is open in WinCC flexible or WinCC.
● The project is compiled.
● The HMI device is connected to a configuring PC.
● The data channel is configured on the HMI device
● The HMI device is in "Transfer" mode.
● The automatic transfer is activated in the data channel for the transfer
● The project is started on the HMI device.
Basic Panels
Operating Instructions, 04/2012, A5E02421799-03
Commissioning a project
6.4 Transfer
93