Installing On A Din Rail - Siemens SCALANCE W788C-2 Series Operating Instructions Manual

4.4

Installing on a DIN rail

The SCALANCE W7x8 is suitable for rail mounting on 35 mm DIN EN 50022 rails.
Bracket for DIN rail mounting
Note
The bracket for installation on a DIN rail does not ship with the product, seeAccessories
(Page 15).
The bracket consists of the following parts:
● 1 DIN rail slider
● 1 spring
● 2 screws
Mount the bracket on the rear of the device as shown in the figure below:
Figure 4-3
Installing on the DIN rail
The following figure shows the W7x8 mounted on a DIN rail. Follow the steps outlined below:
1. Place the device on the upper edge of the DIN rail (position A).
2. Pull the spring-mounted DIN rail slider (position B) down and press the device against the
DIN rail until it locks in place.
SCALANCE W788C-2
Operating Instructions, 01/2017, A5E03692120-11
Fitting the DIN rail slider
Mounting
4.4 Installing on a DIN rail
27