Selecting Parameter Assignment Mode - Siemens LOGO! Series Manual

Configuring LOGO!

7.1 Selecting parameter assignment mode

7.1 Selecting parameter assignment mode
Press ESC to change from RUN to parameter assignment mode:
Note
The following applies to earlier device versions up to 0BA2: you open parameter assignment
mode by pressing ESC+OK.
LOGO! changes to parameter assignment mode and opens the parameter assignment
menu:
Description of the four menu items of the parameter assignment menu
● Menu command ①
You select this command to stop your circuit program and thus change to the main menu of
programming mode. To do so:
1. To move the '>' cursor to "
2. To confirm "
3. To move the '>' cursor to "
4. To confirm "
288
①
": Press
①
"': Press OK
⑦
": Press
⑦
": Press OK
or
or
Manual, 04/2011, A5E03556174-01
LOGO!