Siemens LOGO! Series Manual page 94

Programming LOGO!
3.7 Writing and starting the circuit program
Deactivating the password from the LOGO! Basic
To deactivate the password to allow, for example, another user to edit your circuit program,
you must know your current password (in our example "ZZ"), the same as if you were
changing it.
To deactivate the password, follow these steps in the programming menu:
1. Move the '>' cursor to "
2. Confirm "
3. Confirm the "blank" password: Press OK
The password is "cleared", and LOGO! returns to the programming menu.
Note
This action disables the password prompt, and thus permits access without a password.
Leave the password deactivated for quicker progress through the remaining exercises and
examples.
Password: Wrong Password!
If you enter the wrong password and confirm the input with OK, the LOGO! Basic does not
open editing mode, but returns to the programming menu. This repeats itself over and over
again until you enter the correct password.
94
①
": Press OK
Enter your current password as described in steps 3 to 5 above. Confirm your entries with
OK.
The display shows:
Clear the password by leaving the input box blank:
①
": Press or
Manual, 04/2011, A5E03556174-01
LOGO!