Writing And Starting The Circuit Program; Selecting Programming Mode - Siemens LOGO! Series Manual

3.7

Writing and starting the circuit program

The example below shows how to create a program for your circuit design in LOGO!.
3.7.1

Selecting programming mode

You have connected LOGO! to the power supply and switched it on. The display now shows
you the following message:
Switch LOGO! to programming mode by pressing ESC. This will take you to the main menu
of LOGO!.
The LOGO! 0BA6 main menu is as shown below:
The LOGO! 0BA7 main menu is as shown below:
The first character in the first line is the ">" cursor. Press
and down. Move it to "
LOGO!
Manual, 04/2011, A5E03556174-01
①
" and confirm with OK. LOGO! opens the programming menu.
Programming LOGO!
3.7 Writing and starting the circuit program
and to move the ">" cursor up
83