Mounting The Device On A Din Rail; Mounting The Device To A Rack - Siemens RUGGEDCOM RS400 Installation Manual

RUGGEDCOM RS400
Installation Guide
NOTE
For detailed dimensions of the device with either rack, DIN rail or panel hardware installed, refer to
Section 5.8, "Dimension
CONTENTS
• Section 2.3.1, "Mounting the Device on a DIN Rail"
• Section 2.3.2, "Mounting the Device to a Rack"
• Section 2.3.3, "Mounting the Device to a Panel"
Section 2.3.1

Mounting the Device on a DIN Rail

For DIN rail installations, the RUGGEDCOM RS400 can be equipped with panel/DIN rail adapters pre-installed on
each side of the chassis. The adapters allow the device to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Align the adapters with the DIN rails and slide the device into place.
2
Figure 2: DIN Rail Mounting
1. Panel/DIN Rail Adaptor 2. DIN Rail 3. Screw
2. Install one of the supplied screws on either side of the device to secure the adapters to the DIN rails.
Section 2.3.2

Mounting the Device to a Rack

For rack mount installations, the RUGGEDCOM RS400 can be equipped with rack mount adapters pre-installed at
the front or rear of the chassis. Additional adapters are provided to further secure the device in high-vibration or
seismically active locations.
To secure the device to a standard 48 cm (19 in) rack, do the following:
Mounting the Device on a DIN Rail
Drawings".
Chapter 2
Installing the Device
1
3
2
9