Siemens LOGO! Series Manual page 102

Programming LOGO!
3.7 Writing and starting the circuit program
In our example we do not use the reset input of the off-delay function, and we identify it with
an 'x' connector.
Assigning block parameters
Now you set the off-delay time T:
1. Move the cursor to Par, if it not already at this position: Press
2. Switch to editing mode: Press OK
LOGO! shows the parameters in the parameter assignment window:
To change the time value:
● Press
● Press
● Confirm your entries with OK.
Setting the time
Set the time T = 12:00 minutes:
1. Move the cursor to the first digit: Press
2. Select the digit '1': Press
3. Shift the cursor to the second digit: Press
4. Select digit '2': Press
5. Move the cursor to the unit: Press
6. Select the timebase 'm' (for minutes): Press
102
and to position the cursor.
and to modify the value at the relevant position.
or
or
or
or
or
or
or
Manual, 04/2011, A5E03556174-01
LOGO!