Deleting A Block - Siemens LOGO! Series Manual

3.7.8

Deleting a block

Let us assume you want to delete the block B2 from your circuit program and connect B1
directly to Q1.
Proceed as follows:
1. Switch LOGO! to programming mode
2. Select "
3. Confirm"
4. Select "
5. Confirm "
6. Move the cursor to B2, the input of Q1: Press
7. Confirm with OK.
8. Now replace block B2 with block B1 at output Q1. The procedure:
Result: Block B2 is deleted, because it is no longer used in the circuit. Block B1 has replaced
B2 directly at the output.
LOGO!
Manual, 04/2011, A5E03556174-01
(as a reminder, refer to the topic "The four golden rules for operating LOGO!" (Page 79)).
①
": Press or
①
": Press OK
(If required, enter your password and confirm with OK.)
②
": Press or
②
": Press OK
– Select the BN list: Press
– Accept the BN list: Press OK
– Select 'B1': Press
– Apply 'B1': Press OK
or
or
Programming LOGO!
3.7 Writing and starting the circuit program
105