Siemens LOGO! Series Manual page 244

LOGO! functions
4.4 Special functions list - SF
Setting the Par parameter
View in programming mode (example):
1. Select the 'Softkey' function.
2. Select input En and confirm with OK. The cursor is now positioned below 'Par'.
3. Change to the input mode of 'Par': Confirm with OK
4. To select 'Momentary pushbutton' or 'Switch' action: Press
5. To change to the start state: Press
6. To change the start state: Press
7. Confirm your entries with OK
View in parameter assignment mode (example):
Here, you can set or reset the 'Switch' parameter (On/Off). When in RUN, LOGO! shows the
following display:
244
(the cursor is now positioned to 'On')
To change 'Par' to 'Switch' action and the initialization status after the program start:
or
or
or
Manual, 04/2011, A5E03556174-01
LOGO!