Siemens LOGO! Series Manual page 241

Editing message texts
Only simple message texts can be edited from the LOGO! Basic. Text messages created in
LOGO!Soft Comfort that make use of new features such as bar graphs, I/O status names,
and others can not be edited from the LOGO! Basic.
Also, you cannot edit message texts from the LOGO! Basic that contain any of the following
parameters:
● Par
● Time
● Date
● EnTime
● EnDate
You can only edit such message texts from LOGO!Soft Comfort.
Changing parameters in the active message text
When the message text is active, press ESC to select the editing mode.
Note
You must keep the ESC key pressed for at least one second.
Press
and
Confirm your changes with OK. You can now edit further parameters in the message text (if
any exist). Press ESC to exit editing mode.
Key input simulation in the active message text
You can enable the four cursor keys C , C , C
pressing ESC plus the relevant cursor key.
LOGO!
Manual, 04/2011, A5E03556174-01
and to select the relevant parameter. Press OK to change the parameter. Use the
keys to edit a parameter.
4.4 Special functions list - SF
and C in an active message text by
LOGO! functions
241