Siemens LOGO! Series Manual page 84

Programming LOGO!
3.7 Writing and starting the circuit program
The LOGO!'s programming menu is as shown below:
Here you can also move the ">" cursor by pressing
confirm with OK.
The Edit menu of LOGO! is as shown below:
Move the ">" cursor to "
shows you the first output:
You are now in programming mode. Press
edit your circuit program.
Note
Because we have not yet saved a password for the circuit program in LOGO!, you can
directly enter editing mode. When you select "Edit" after you have saved a password-
protected circuit program, you are prompted to enter a password and to confirm it with OK.
You can only edit the program after you have entered the correct password (Page 91).
84
③
" (for editing the circuit program) and confirm with OK. LOGO! now
and
and . Move the ">" cursor to "
to select the other outputs. Now start to
Manual, 04/2011, A5E03556174-01
②
" and
LOGO!