Siemens LOGO! Series Manual page 114

Programming LOGO!
3.7 Writing and starting the circuit program
Note
You can specify a time zone difference Δ between 0 and 180 minutes.
The US2 selection is only supported in LOGO! devices as of the series 0BA6.
Let us assume you want to enable European summertime/wintertime conversion:
1. Move the '>' cursor to 'EU': Press
2. Confirm 'EU': Press OK
LOGO! shows the following display:
LOGO! indicates that European S/W Time conversion is enabled.
User-defined parameters
If none of the parameters/conversions apply to your country, you can customize these under
menu item '. .'. To do so:
1. Confirm 'On' once again: Press OK
2. Move the '>' cursor to '. .': Press
3. Confirm the menu item '. .' : Press OK
The display shows:
Let us assume you want to configure the following parameters: Start of summertime = 31st
March, end of summertime = 1st November, time difference of 120 minutes.
This is how you can enter your data:
● Press
● Press
114
or to move the solid square/cursor.
and to change the value at the cursor position.
or
or
Manual, 04/2011, A5E03556174-01
LOGO!