Remote Communication And Control; Connection Options; Rs-232 Port - Extron electronics SMP 351 User Manual

Remote
Communication and
Control
This section describes SIS programming and control of the SMP 351, including:
•
•
•

Connection Options

The SMP 351 Streaming Media Processor can be remotely connected via a host computer
or other device (such as a control system) to the rear panel RS-232 port or LAN port, or the
front panel USB Config port.
The SMP 351 can be configured and controlled using SIS commands or embedded web
pages. SIS commands can be executed using the Extron DataViewer program, found on
the Extron Website at www.extron.com.
RS-232 protocol defaults:
•
•
See RS-232 Port, for additional details on connecting the RS-232 port.
USB port details:
The Extron USB driver must be installed before use (see
on page 157) .
LAN port defaults:
DHCP:
SMP 351 IP address: 192.168.254.254
Subnet mask:
Gateway IP address: 0.0.0.0

RS-232 Port

The SMP 351 has a rear panel serial port (see
be connected to a host device such as a computer running a HyperTerminal utility, or the
Extron DataViewer utility. The port makes serial control of the media processor possible.
Use the protocol information listed above to make the connection (see
Communications
Connection Options
Host-to-device Communications
Command and Response Tables
9600 baud • no parity
8 data bits • no flow control
off
255.255.0.0
on page 159).
• 1 stop bit
Front Panel Configuration Port
figure 3, item
E
SMP 351 • Remote Communication and Control
on page 12) that can
Host-to-device
156