Programming; Symbols For The Properties Description; P0105 - 1 St /2 Nd Ramp Selection; P0220 - Local/Remote Selection Source - WEG CFW-11 User Manual

3 PROGRAMMING

Next, only the CFW-11 frequency inverter parameters related to the Anybus-CC communication will be
presented.
3.1

SYMBOLS FOR THE PROPERTIES DESCRIPTION

RO Read-only parameter
CFG Parameter that can be changed only with a stopped motor
Parameter visible on the HMI if the device has the network interface installed – RS232, RS485, CAN,
NET
Anybus-CC, Profibus – or if the USB interface is connected
P0105 – 1 /2 RAMP SELECTION
ST ND
P0220 – LOCAL/REMOTE SELECTION SOURCE
P0221 – SPEED REFERENCE SELECTION – LOCAL SITUATION
P0222 – SPEED REFERENCE SELECTION – REMOTE SITUATION
P0223 – FORWARD/REVERSE SELECTION – LOCAL SITUATION
P0224 – RUN/STOP SELECTION – LOCAL SITUATION
P0225 – JOG SELECTION – LOCAL SITUATION
P0226 – FORWARD/REVERSE SELECTION – REMOTE SITUATION
P0227 – RUN/STOP SELECTION – REMOTE SITUATION
P0228 – JOG SELECTION – REMOTE SITUATION
These parameters are used in the configuration of the command source for the CFW-11 frequency inverter local
and remote situations. In order that the device be controlled through the Anybus-CC interface, the options
'Anybus-CC' available in these parameters, must be selected.
The detailed description of these parameters is found in the CFW-11 programming manual.
P0313 – COMMUNICATION ERROR ACTION
Range: 0 = Inactive
1 = Disable via Run/Stop
2 = Disable via General Enable
3 = Change to Local
4 = Change to Local keeping commands and reference
5 = Causes a Fault
Properties: CFG
Access groups
via HMI:
Description:
It allows the selection of the action to be executed by the device, if it is controlled via network and a
communication error is detected.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
01 PARAMETER GROUPS
∟
49 Communication
∟
111 Status and commands
Default: 1