Printing Check Flow; Printing Operations At "Nozzle Missing" Judgment And Error Occurrence; Printing Operations At "Nozzle Missing" Judg- Ment And Error Occurrence - MIMAKI UJF-7151 plus Operation Manual

Chapter 3 Setup

Printing Check Flow

Nozzle check is conducted according to the following flow at the start of printing.
• Turn the "Printing Check" setting ON to be enabled.
• Only perform RETRY COUNT and Printing Check settings when the settings are enabled.
1
nozzle check  Judgment
2
Recovery operation 
nozzle check  Judgment
3
Retry  Judgment
4
Printing Check  Judgment
5
Nozzle Missing judgment

Printing Operations at "Nozzle Missing" Judgment and Error Occurrence

 When judged to be "Nozzle Missing"
 When error occurs during nozzle check
3-30
Detects missing nozzles.
If more missing
Condition" are detected after the nozzle check,
cleaning is performed and nozzle check is
conducted again.
If more missing
Condition" are detected after the recovery
operation, the recovery operation is conducted
again.
• If the "RETRY COUNT" setting is configured to 1 or more,
this becomes effective.
Nozzle recovery is automatically conducted
following nozzle check and recovery operation.
• Turn the "Printing Check" setting ON to be enabled.
If more missing nozzles than A are eventually
detected, continued printing will be deemed
impossible and printing will stop.
 Printing is stopped.
 Printing is stopped and "Printing Check" is automatically turned
OFF. After recovering from the error, set "Printing Check" once
again.
nozzles than "Judgement
nozzles than "Judgement