Chapter 3 Nozzle Check
Printing Check Flow
Nozzle check is conducted according to the following flow at the start of printing.
• Turn the "Printing Check" setting ON to be enabled.
• Only perform RETRY COUNT and Printing Check settings when the settings are enabled.
1
nozzle check Judgment
2
Recovery operation
nozzle check Judgment
3
Retry Judgment
4
Printing Check Judgment
5
Nozzle Missing judgment
Printing Operations at "Nozzle Missing" Judgment and Error Occurrence
When judged to be "Nozzle Missing"
When error occurs during nozzle check Printing is stopped and "Printing Check" is automatically
3-24
Detects missing nozzles.
If
more
missing
Condition " are detected after the nozzle check,
cleaning is performed and nozzle check is
conducted again.
If more missing nozzles than "Judgement Condition "
are detected after the recovery operation, the recovery
operation is conducted again.
• If the "RETRY COUNT" setting is configured to 1 or more,
this becomes effective.
Nozzle recovery is automatically conducted
following nozzle check and recovery operation.
• Turn the "Printing Check" setting ON to be enabled.
If more missing nozzles than A are eventually
detected, continued printing will be deemed
impossible and printing will stop.
Printing is stopped.
turned OFF. After recovering from the error, set "Printing
Check" once again.
nozzles
than
"Judgement