Advanced Commissioning - Siemens SINAMICS G110M Operating Instructions Manual

Advanced commissioning

6.2 Inverter control
Default setting 34, slave 2 with profile 7.A.E: Control -> inverter
• AS-i.DO0
• AS-i.DO1
• AS-i.DO2
• AS-i.DO3
If the control specifies the speed setpoint, the inverter replies:
Default setting 34, slave 2 with profile 7.A.E: Inverter -> control
• p2080[0] = 53.13
• p2080[1] = 899.11 Pulses enabled
• p2080[2] = 722.0
• p2080[3] = 722.1
If the control sends a diagnostic request via AS-i.P0, the inverter replies with the currently
pending fault or alarm messages.
(https://support.industry.siemens.com/cs/gb/en/view/1171856).
Default setting 34, slave 1 with profile 7.A.5: Control -> inverter
• AS-i.DO0
• AS-i.DO1
• AS-i.DO2
• AS-i.DO3
Default setting 34, slave 1 with profile 7.A.5: Inverter -> control
• p2080[4] = 722.2
• p2080[5] = 722.3
• Serial data transfer CTT2, four bytes cyclically or acyclically via PIV.
The reading and writing of parameters is possible via the PIV.
Because data is transferred bit-by-bit, the read and write process is
very slow.
• Time signal for the CTT2 transfer to the AS-i master
156
-> ON / OFF 1
-> OFF 2
-> Acknowledge fault
-> Select slave A or slave B, interconnected internally
PLC ready to switch on
State DI0
State DI1
AS-i System Interface Manual
-> Time signal for the CTT2 transfer from the AS-i master
-> Data bit for the CTT2 transfer, four bytes cyclically or acyclically via
PIV. The reading and writing of parameters is possible via the PIV.
Because data is transferred bit-by-bit, the read and write process is
very slow.
-> p0881 = 2093.4
-> Select slave A or slave B, interconnected internally
State DI2
State DI3
->
->
->
->
Override quick stop
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 06/2016, FW V4.7.6, A5E31298649B AG
AS-i.DI0
AS-i.DI1
AS-i.DI2
AS-i.DI3
-> AS-i.DI0
-> AS-i.DI1
-> AS-i.DI2
-> AS-i.DI3