What Do You Need For Communication Via Profinet; Connect The Converter To Profinet - Siemens SINAMICS G110M Operating Instructions Manual

General information about PROFINET
You can find general information about PROFINET in the Internet:
● General information about PROFINET: Industrial Communication
(http://support.automation.siemens.com/WW/view/en/19292127).
● Configuring the functions: PROFINET system description
(http://www.automation.siemens.com/mcms/automation/en/industrial-
communications/profinet/Pages/Default.aspx).
This manual describes the control of the inverter using primary control. Accessing the
inverter as an Ethernet node is described in the "Fieldbus" function manual.
4.4.2.1

What do you need for communication via PROFINET?

Check the communication settings using the following table. If you answer "Yes" to the
questions, you have correctly set the communication settings and can control the inverter via
the fieldbus.
Questions
Is the inverter correctly connected to
the bus network?
Do the IP address and device name
in the inverter and control match?
Is the same telegram set in the in-
verter as in the higher-level control?
Are the signals that the inverter and
the control exchange via PROFINET
correctly interconnected?
4.4.2.2

Connect the converter to PROFINET

Procedure
To connect the inverter to a control via PROFINET, proceed as follows:
1. Integrate the inverter in the bus system (e.g. ring topology) of the control using
PROFINET cables and the two PROFINET jacks X03 and X04.
The maximum permitted cable length from the previous station and to the subsequent
one is 100 m.
2. Externally supply the inverter with 24 V DC through X01.
You have connected the inverter to the control using PROFINET.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 06/2016, FW V4.7.6, A5E31298649B AG
Manuals for your converter (Page 335)
Connection and cables (Page 65)
4.4 Connecting the inverter to the fieldbus
Answer/description
Connect the converter to
PROFINET (Page 85)
Configuring communica-
tion to the control (Page 86)
Setting the telegram in the con-
trol
Interconnect signals PROFIdrive-
conform in the inverter.
Control via PROFIBUS or
PROFINET with the PROFIdrive
profile (Page 139)
Installation
Example
Inverter manuals,
"Fieldbus" function manual
(Page 335)
85