Setpoint Calculation; Overview Of Setpoint Processing; Advanced Commissioning - Siemens SINAMICS G110M Operating Instructions Manual

Advanced commissioning

6.4 Setpoint calculation

Parameter
...
p1015
p1016
p1020
p1021
p1022
p1023
r1024
r1025.0
6.4 Setpoint calculation
6.4.1

Overview of setpoint processing

The setpoint can be modified as follows using the setpoint processing:
● Invert setpoint to reverse the motor direction of rotation (reversing).
● Inhibit positive or negative direction of rotation, e.g. for conveyor belts, pumps or fans.
● Skip frequency bands to prevent mechanical resonance effects.
The skip frequency band at speed = 0 results in a minimum speed after switching on the
motor.
● Limit to a maximum speed to protect the motor and mechanical system.
● Ramp-function generator to accelerate and brake the motor with an optimum torque.
Figure 6-25
172
Description
...
Fixed speed setpoint 15 (factory setting: 0 rpm)
Speed fixed setpoint mode (factory setting: 1)
1: Direct
2: Binary
Speed fixed setpoint selection bit 0 (factory setting: 0)
Speed fixed setpoint selection bit 1 (factory setting: 0)
Speed fixed setpoint selection bit 2 (factory setting: 0)
Speed fixed setpoint selection bit 3 (factory setting: 0)
Fixed speed setpoint effective
Fixed speed setpoint status
1 signal Fixed speed setpoint is selected
Setpoint processing in the converter
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 06/2016, FW V4.7.6, A5E31298649B AG