Siemens SINAMICS G110M Operating Instructions Manual page 102

Commissioning
5.3 Basic commissioning
When the SINAMICS G110M is ordered and delivered as a complete system, the motor data
is already correctly configured and does not require any adjustment.
When the SINAMICS G110M is ordered and delivered as separate items, the user must
install the system and enter the relevant motor data during basic commissioning.
When commissioning of the motor is required, there are two options available to the user:
Commissioning using motor codes
When commissioning using the motor codes, for example, in STARTER utilizing the "Expert
List", the follow steps should be performed:
1. Set p0010 = 1.
2. Set p0300 to 100 (1LE1 standard induction motor) or 177 (1LA7 standard induction
motor).
3. Enter the relevant motor code into p0301 as shown in the following table:
Motor type
1LA7
1LE1
1LE1
1LE1
1LE1
1LE1
1LE1
When the relevant motor code is entered, the motor data automatically assigned for the
selected motor. The user can then complete the commissioning process without the need to
perform a motor ID.
Commissioning without using motor codes
When commissioning the system without using motor codes, the following steps must be
performed, otherwise the motor will not be commissioned correctly.
1. Set p0010 = 1 (Enter the quick commissioning mode).
2. Set p0300 = 1 (Induction motor [rotating]).
3. Set p0301 = 0 (This disables the automatic motor data assignment).
4. Complete the commissioning process, entering the motor data (from the motor rating
label) into the relevant parameters.
5. Set p3900 = 1, 2 or 3 to end quick commissioning, depending on the users requirements.
102
Power rating (kW)
0.37
0.75
1.10
1.50
2.20
3.00
4.00
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 06/2016, FW V4.7.6, A5E31298649B AG
Motor code for p0301
17726
12017
12018
12019
12020
12021
12023