Siemens SINAMICS G110M Operating Instructions Manual page 301

Number Cause
A07922 Torque/speed out of tolerance
F07923 Torque/speed too low
F07924 Torque/speed too high
A07927 DC braking active
A07980 Rotary measurement activated
A07981 No enabling for rotary measure-
ment
A07991 Motor data identification activated
F08501 Setpoint timeout
F08502 Monitoring time sign-of-life expired
F08510 Send configuration data not valid
A08511 Receive configuration data not
valid
A08526 No cyclic connection
A08565 Consistency error affecting adjust-
able parameters
F13100 Know-how protection: Copy protec-
tion error
F13101 Know-how protection: Copy protec-
tion cannot be activated
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 06/2016, FW V4.7.6, A5E31298649B AG
Remedy
Check the connection between the motor and the load.
•
Adapt the parameterization corresponding to the load.
•
Check the connection between the motor and the load.
•
Adapt the parameterization corresponding to the load.
•
Not required
Not required
Acknowledge pending faults.
Establish missing enables (see r00002, r0046).
Switch on the motor and identify the motor data.
Check the PROFINET connection.
•
Set the controller to RUN mode.
•
If the error occurs repeatedly, check the set monitoring time p2044.
•
Check the PROFINET connection.
•
Check the PROFINET configuration
•
Activate the controller with cyclic operation.
•
Check the parameters "Name of Station" and "IP of Station" (r61000,
•
r61001).
Check the following:
IP address, subnet mask or default gateway is not correct.
•
IP address or station name used twice in the network.
•
Station name contains invalid characters.
•
The know-how protection and the copy protection for the memory card
are active. An error occurred during checking of the memory card.
Insert a suitable memory card and switch the converter supply voltage
•
temporarily off and then on again (POWER ON).
Deactivate the copy protection (p7765).
•
Insert a valid memory card.
Alarms, faults and system messages
9.6 List of alarms and faults
301