Toyota Land Cruiser 1988 Repair Manual page 9

IN-4
3F-E Engine
INTRODUCTION - Identification Information, General Repair Instructions
IDENTIFICATION INFORMATION
VEHICLE IDENTIFICATION NUMBER
The vehicle identification number is stamped on the cowl panel
: of the engine compartment. This number is also stamped on
I
!m
top of the instrument panel and the driver's door post.
I
I
I
I
IN0013
IN0037
ENGINE SERIAL NUMBER
The engine serial number is stamped on the right side of the
cylinder block.
GENERAL REPAIR INSTRUCTIONS
1. Use, seat and floor covers to keep the vehicle clean and
prevent damage.
2. During disassembly, keep parts in order to facilitate
reassembly.
3. Observe the following:
(a) Before performing electrical work, disconnect the
negative cable from the battery terminal.
(b) If it is necessary to disconnect the battery for inspec-
tion or repair, always disconnect the cable from the
negative (-) terminal which is grounded to the vehi-
cle body.
(c) To prevent damage to the battery terminal post,
loosen the terminal nut and raise the cable straight up
without twisting it or prying it.
(d) Clean the battery terminal posts and cable terminals
with a shop rag. Do not scrape them with a file or
other abrasive object.
(e) Install the cable terminal to the battery post with the
nut loose, and tighten the nut after installation. Do
not use a hammer to tap the terminal onto the post.
(f) Be sure the cover for the positive (+)terminal is pro-
perly in place.
4. Check hose and wiring connectors to make sure that they
are secure and correct.