Toyota Land Cruiser 1988 Repair Manual page 276

CHARGING SYSTEM -Alternator CH-7
CH0569
DISASSEMBLY OF ALTERNATOR
(See page CH-6)
1. REMOVE DRIVE END FRAME AND ROTOR
ASSEMBLY FROM STATOR
(a) Remove the three through screws.
(b) Using a screwdriver, pry the end frame and remove
it together with the rotor.
CAUTION: Do not pry on the coil wires.
2. REMOVE PULLEY, FAN AND DRIVE END FRAME
FROM ROTOR
(a) Mount the rotor in a soft jaw vise.
(b) Remove the pulley nut, spring washer, pulley and
fan.
(c) Remove the spacer collar and drive end frame.
(d) Remove the spacer ring and snap ring.
3. REMOVE RECTIFIER END FRAME
(a) Remove the four nuts, condenser and two terminal
insulators.
(b) Remove the rectifier end frame.
(c) Remove the insulator washer from the rectifier
holder stud.