Toyota Land Cruiser 1988 Repair Manual page 65

EM-34 ENGINE MECHANICAL- Timing Gears and Camshaft
REMOVAL OF TIMING GEARS AND
CAMSHAFT
(See page EM-33)
1. DRAIN ENGINE COOLANT
(See page C0-3)
2. DISCONNECT ACCELERATOR AND THROTTLE
CABLES
3. REMOVE AIR INTAKE HOSE, AIR FLOW METER
AND AIR CLEANER ASSEMBLY
(a) Disconnect the air flow meter connector and clamp.
(b) Disconnect following hoses:
• ISC hose
• Air pump hose
• Distributor hose
• PCV hose
• Three hoses from the intake chamber rear side
• Two hoses from the VCV of the charcoal canister
(c) Loosen the air intake hose clamp.
(d) Remove the wing nut and loosen the three clips,
and remove the air intake hose, air flow meter and air
cleaner cap.
4. LOOSEN PS DRIVE PULLEY NUT
Push on the drive belt to hold the pulley in place and
loosen the pulley nut
5. REMOVE FLUID COUPLING WITH FAN AND
WATER PUMP PULLEY
(See steps 2 to 6 on pages C0-4, 5)
6. REMOVE PS PUMP AND A/C COMPRESSOR
(See steps 6 and 7 on page EM-12)
7. REMOVE PS AND A/C COMPRESSOR
BRACKETS
8. REMOVE PS IDLER PULLEY AND BRACKET
ASSEMBLY
9. REMOVE DISTRIBUTOR
10. REMOVE VALVE ROCKER SHAFT ASSEMBLY
(See steps 21 to 23 on pages EM-14, 15)
11. REMOVE PUSH ROD COVER
Remove the ten bolts, two nuts, push rod cover and
gasket.